In Austin, the first real cold snap tends to arrive suddenly, and that is when most people remember the fireplace. A fireplace that sat unused all spring and summer is not necessarily ready to go. Birds and squirrels move in, leaves and debris collect, and creosote from last winter is still there. This checklist covers what to look at before you light anything.
Creosote is the tar-like residue that wood smoke leaves on the inside of the flue. It starts as a light, flaky soot, but over time it can harden into a shiny, tar-like glaze that is hard to remove and burns very hot if it catches fire. Shine a flashlight up the flue from the firebox. If you see thick black buildup, or the flue looks glossy rather than dusty, do not burn until it has been cleaned. Even occasional use leaves creosote behind, which is why a fireplace you barely use still needs checking.
Open and close the damper a few times. It should move freely and open fully. A damper that is stuck, warped or rusted can leave the flue partly blocked, which pushes smoke back into the room. If it does not open all the way, have it looked at before the season starts.
Stand back and look at the top of the chimney. The cap keeps rain, birds and animals out, and the crown is the concrete or metal surface around the flue. Look for a missing or bent cap, cracks in the crown, and bricks or mortar that are crumbling. Water getting into a chimney causes damage over time, and a missing cap invites animals to nest.
Chimneys are attractive to birds, squirrels and raccoons. Listen for scratching or chirping, and look for twigs, leaves or fur in the firebox. Never light a fire to drive animals out. Blocked flues can fill the house with smoke and carbon monoxide, and nests are flammable. If you suspect an animal, call a professional.
Look for cracked or missing firebricks, gaps in the mortar and anything stored near the fireplace that does not belong there. Clear the area of rugs, paper, firewood stacks and decorations. Keep a sturdy screen in front of the opening, and make sure the hearth extends far enough to catch stray embers.
Put fresh batteries in your detectors and test them before you start using the fireplace. Carbon monoxide has no smell, so an alarm is the only warning you get. Place a detector on each level of the house and near the bedrooms.
A proper visit is more than brushing the flue. The sweep removes creosote and soot from the flue and the firebox, clears debris and nests from the chimney, and checks the damper, the cap and the visible parts of the masonry. Afterward, you should be told what was found, whether the chimney is safe to use, and whether anything needs repair. If a problem needs a mason or a repair specialist, a good sweep will tell you that plainly instead of trying to fix everything.
The common guidance is an inspection every year, with a sweep whenever the inspection shows it is needed. If you burn wood often through the winter, you may need more than one. If you use the fireplace only now and then, a yearly check still makes sense, since creosote, debris and animals do not wait for you to use it. Gas fireplaces and inserts also need an annual check of the venting and the burner area.
Fire safety organizations recommend having a chimney inspected every year, and swept when it needs it. If you notice creosote, a stuck damper, animals or smoke coming back into the room, book before you light the first fire. Our chimney cleaning and sweeping removes creosote, clears debris and checks the flue for blockages. If you want to know more about why a barely used fireplace still matters, read why chimney sweeping matters even if you rarely use it.
You can request a free inspection and a clear quote from Omega Duct Cleaning, based at 3704 Bonnie Rd in Austin. We also clean air ducts and dryer vents, so one visit can cover more than the chimney.
Book a sweep and a safety check before the cold sets in.